Honda Integrated Garage Door Opener Installation Procedures

1. Acquire an extra storage door opener remote management for your door, when you have only one remote control. You can be reducing aside this unit, so make sure that it is not the only garage door opener remote management you have. Purchase extra remote control units out of your garage door opener manufacturer.
2. Loosen the screws on the opener remote control and pull the housing apart.
3. Study the floor of the circuit board of the garage door opener, searching for the soldered connections directly beneath the push button. There may be four or eight soldered connections, relying in your remote control model.
4. Press down on the garage door button and keep it affixed in place with a chunk of duct tape. It will hold the circuit closed for testing. Take one finish of the multimeter probe and contact one of the soldered connections. Contact the other end of the probe to an adjoining connection. Watch the needle on the multimeter. If it falls to zero, you’ve discovered the connections that that you must solder together. If not, try a different reference to the second multimeter probe. You’re looking for the pairs of nodes that have zero resistance throughout one another for soldering together. Once you’ve discovered the first pair, continue working till you’ve recognized all the nodes and their zero-resistance partners.
5. Heat up the solder on the primary reference to the tip of a soldering iron to soften it. Insert the end of the first little bit of insulated wire. Apply solder to the top of the wire and soften it with the tip of the soldering iron. Repeat this course of for the free end of the insulated wire, soldering it to the first connection’s zero-resistance partner. Repeat the process of wiring the zero-resistance pairs together with the soldering iron and wire.
6. Take away the 9V battery cap connection wires from the battery terminals on the circuit board by reducing it with wire cutters. Solder two more connections from the positive and negative battery terminals on the garage door opener.
7. Join the wire related to the negative battery terminal on the opener to the negative wire of a 9-volt battery cap that you simply minimize off the circuit board earlier. Connect the positive terminal from the 9-volt cap to a wire with a Quick-fit connector change at the end.
8. Connect the positive battery terminal on the opener to a wire with a quick-match connector.
9. Look for a location in your Honda dashboard that may maintain the body of the garage door change comfortably. For instance, in 2003 to 2007 Honda Accords, take away the fuse panel cover, after which the fuse panel collar, to succeed in an open area behind the dashboard. Additionally word that you’ll want sufficient wiring to run from the change in the dash to the storage door opener remote management location.
10. Find a connector change that matches into one of the free sockets of your Honda dashboard. Discover them low-cost at on-line or bodily retailers. You could need to check several until you find one that fits. Fasten a quick connector change to the positive and negative terminals on the switch. Remove any unused switch panels on the sprint, such as the place non-compulsory equipment such as defroster switches may me mounted, and mount the new switch. How you’ll mount the new swap is determined by the type of kit that you simply purchased. Most will come with screws that can you can drive by the swap and into the dashboard.
11. Join the 9-volt battery to the battery cap. Trim out any parts of the garage door opener as needed so the wires operating out don’t get bent, and fasten the garage door remote housing again together.
12. Mount the door opener remote control in a hidden a part of your dashboard or glove box. Don’t make the mounting permanent, as you’ll ultimately have to alter the battery.
13. Connect one wire from the switch to the battery meeting cap and the opposite to the storage door opener remote control by pressing the quick-match connections together.